LED Headlamp
Originally developed for the
military market, Mobile Centre have made this high end technology available
directly to the end user, and in every case where this product was supplied it
has exceeded the customers expectations which were already high. The light on
the road is four times greater with these lamps compared to sealed beam,
combined with the near daylight white colour of light transforms the night time
driving experience.
Click here to
download a feature published in Land Rover Monthly Magazine May 2010
www.lrm.co.uk covering LED products and the
installation of these units.
When replacing a sealed beam the amount of
useable light on the road is four times greater with these LED headlamps yet
power requirement is less than 30 watts. The lamps are dual voltage so will work
on 12 or 24 volt vehicles without adjustment.
The units have a glass cover which has
been impact tested to military standards which requires dropping a steel ball
bearing on the glass from 1m, because of the efficiency of LEDs the lamp runs
much cooler so there is no risk of cracking a hot glass lens when driving
through water but just to make sure extensive testing has been carried out with
the lamp heated to 100 degrees centigrade
As you can see it is a direct plug and
play replacement for a H4 fitting.
Click here to download a data sheet
- Conforms & certified to ECE R112
regulation for head lights.
- DOT & MIL spec on request
- PAR 56 / 7" round type 2D1
- Sealed to IP 67
- Military spec conforms to
MIL-STD-461 (US military standard for EMC)
- 20,000 hour life
- Four times more light output than standard sealed
beam
- Double the light output of a H4
halogen.
- Higher colour temperature - much closer to that
of natural daylight
- Nominal current draw 2.5A @ 12 volts
DC
This in no way definitive but offered as a rough guide
ONLY:
- Halogen bulb life 200 – 500 hours
- Cheap HID 200 – 500 hours
- Branded HID 2000 – 2500
hours
As you can see the LED headlight would outlast
halogen by up to 100 times, and HID by up to 10 times clearly representing the
best value for money over the lifetime of the product.
These lamps will fit any vehicle with 2D1
headlights, however please refer to the drawing to ensure there is enough depth
within the bowl assembly. Standard stcoked product is terminated with a H4
connector as shown but various combinations are available including military
connectors.
Click here to see a video of the unit in
action
Suitable for use in the following
countries
